VINTAGETRACTORS.COM
AND
RUSTY ACRES RANCH
Silver King Transmission, Clutch, Brake, Final Drive
Parts
Not sure just
what you need?
FREE COPY OF AN OLD PARTS CATALOG FOR SILVER KING TRACTORS WITH
HERCULES ENGINE
Just Send me an
Email and ask for one!
Clutch disk, $20,
Clutch pressure plate, $30
Clutch Throw out bearing, $40
PTA 5-30 Clutch bearing support, $25
PTA 5-30 Clutch bearing support and throw out bearing,
$50
PTA 5-6 Clutch Throwout Yoke, with left and right shafts,
$30, you choice
Clutch pedal, $20, your choice
PTA 5-21 Clutch operating lever, with PTA 5-19 yoke
and PTA 5-18A rod, $25
Clutch rod, $10
PTA 4-40 Clutch inspection plate, Is split where circled
in yellow, $5
PTA 10-16 Brake housing cover with spring, $30
PTA 10-16 Brake housing cover with spring, repaired
at area circled in yellow, Spring is present, but it is bolted
and not riveted, $12.50
Brake Lever, $15 each, 2 available
PTA 10-5 Brake Drum, $15. This has a hairline crack
through the setscrew hole, sold as-is
PTA 10-5 Brake Drum, repaired as shown, $15
PTA 4-36 or 4-37, Shim between transmission case and
differential case.$10
PTA 10-20 Differential Assembly, $70
PTA 1-17 Differential Case, $50 (80 lb), your choice
PTA 10-39 or 10-40 Shim between Differential Case and
Final Drive housings, $4 each
PTA 10-14 Right hand Final Drive Gear housing for R-38,
Includes PTA 10-37 Stub shaft, $70 (77 lb)
PTA 10-15 Left hand Final Drive Gear housing for R-38,
Includes PTA 10-37 Stub shaft, $40, Note the small piece broken
out and the extra welding from stub shaft to housing, this is
still in good useable condition. (77 lb)
PTA 10-15 Left hand Final Drive Gear housing for R-38,
Includes PTA 10-37 Stub shaft, $70 (77 lb)
PTA 10-14 Right hand Final Drive Gear housing for R-38,
Includes PTA 10-37 Stub shaft, $70 (77 lb)
PTA 10-35 Oil Seal retainer, $10
PTA 10-7 Driveshaft for 38" tread, with PTA 10-8
pinion gear and PTA 10-33Bearing retainer plate and all associated
parts. $50, two available
PTA 10-65 Gear Housing cover, pressed steel, $30 each
PTA 10-79 Gear cover clamp plate, $15 each
PTA 10-75, Used leather oil seal, to be used as a pattern
to make your new one, $7.50 each
PTA 10-76 Spring for leather seal, $20 each
PTA 10-2 Rear wheel hub cap, $25 each
PTA 8-10 and 8-11, Bearings, inner and outer for PTA
10-1 Rear wheel hub, $15 for the pair
PTA 10-35 Oil Seal Retainer and PTA 10-36 Oil Seal
Washer to be used in PTA 10-1 Rear wheel hub, $17.50 for the set
PTA 10-1 Rear wheel hub, excellent condition, $50,
your choice
PTA 10-42 Nut for the PTA 10-37 stub shaft, $5 each